Any buckle, any strap
Every Railtek buckle fits every Railtek strap. Open the clamp to swap buckles any time you want a new look.
How it works
No holes. No guessing.
Size it once at home, then click it in a quarter inch at a time every day after. Here's how.
Fit it in three steps
-
Open the clamp
Flip open the clamp on the back of the buckle and slide the strap out.
-
Cut to size
Put the strap on through your belt loops, mark where it meets the buckle, and trim it with sharp scissors. Cut a little long the first time. You can always trim more.
-
Reclamp and click
Slide the cut end back into the buckle and press the clamp shut. From then on, push the strap in to tighten a quarter inch at a time.
Watch how it's done
-
How to custom fit
Sizing a new belt, start to finish.
-
How to use it
Putting it on, tightening it, and taking it off.
Good to know
One size, 18" to 50"
One strap covers any waist from 18" to 50". Trim it once and it's sized for you.
Tighten or loosen any time
Push the strap in to tighten a quarter inch at a time. The how-to video above shows how to loosen it and take it off.
Lifetime warranty
Every buckle and strap is covered. See the warranty.